Which is a high-pass filter?
- L type with series L and shunt C.
- L type with series C and shunt L.
- Pi type with series C and L.
Explanation from PART66Online
A high-pass filter must pass high frequencies and block low ones. Placing a capacitor in series (low reactance at high frequency) with an inductor as the shunt arm (low reactance at low frequency, shorting them out) achieves this, so the L-type with series C and shunt L is the high-pass configuration.
arifadli8 asked · 1 Jan 2014
i dont understand that symbol...
Community Comments (3)
High pass filter using capacitor series into circuit, and inductor shunt into earth/ground/neutral.
Capacitor allow higher frequency to pass on (to circuit), blocking lower frequency.
While inductor prevent higher frequency escape(into ground), allowing most of lower frequency return to ground. (DC also)
See Fig 10-221 on page 10-221 of FAA 8083-30 - Chapter 10 - Basic Electricity.
Please Sign In to post a comment.
More discussions in 3. Electrical fundamentals
- If the phase voltage in a star connected generator is 200V what will be the line voltage?
- The frequency of the output of a 4 pole generator is 400 Hz. The generator is turning at
- One revolution of a three phase generator will produce
- The output from a rotating armature AC generator would be taken from
- A generator supplies 150VAC phase and load is 10 Ohms per phase. What is the phase current ?
- A 3 phase generator whose phase and line voltages are different is connected in