A Dial Test Indicator may be used for
- checking a round bar for bow.
- checking dimensions to within 0.125 inch.
- checking any known depth measurement.
Explanation from PART66Online
A dial test indicator reads small plunger movements, so a round bar can be rotated against the stylus and any bow shows up as needle deflection, indicating the run-out. Its fine scale is for small variations, not coarse 0.125 inch steps, and it measures relative movement rather than absolute depths from a datum.
J
Jordi asked · 24 May 2020
D.T.I why isnt the 3d option?Because it says "any"?
Community Comments (0)
No one has posted a comment here yet.
Please Sign In to post a comment.
More discussions in 7. Maintenance practices
- When checking a torque wrench 15 inches long, the load required to give torque of 120 lbs.in. is
- At which frequency is the calibration of frequently used crimping tools carried out?
- The picture shows a torque wrench with an extension. To apply a torque of 350 lb.in. the reading on the dial should be
- A micro-shaver is used to
- When torque loading, a wrench should be selected where the required value falls
- A 3 1/2 bit multimeter will indicate readings up-to