A hydraulic jack has a piston rod (ram) on one side of the piston only. Fluid at equal pressure is applied to both sides of the piston. What happens?
- The piston stays where it is, because the equal pressures on its two faces cancel each other out.
- The piston moves away from the rod side and the rod retracts, because the two faces have different areas.
- The piston moves towards the rod side and the rod extends, because the two faces have different areas.
Explanation from PART66Online
Force equals pressure times area. On the side without the rod the fluid acts on the full piston area; on the rod side the rod covers part of the piston, leaving a smaller ring-shaped (annular) area. At equal pressure the full face therefore produces more force, so the piston moves towards the rod side and the rod extends. The net force equals the pressure times the cross-sectional area of the rod.
elitair asked · 28 Oct 2026
The question is not understandeble in my apinion
Community Comments (2)
The question now reads:
"A hydraulic jack has a piston rod (ram) on one side of the piston only. Fluid at equal pressure is applied to both sides of the piston. What happens?"
The correct answer has not changed, only the wording. On the side without the rod, the fluid pushes on the whole piston face. On the rod side, the rod covers part of the face, so the area is smaller. The same pressure on a bigger area gives a bigger force, so the piston moves towards the rod side and the rod extends.
The three options and the explanation have been rewritten in the same plain terms. If any other question reads badly, please keep telling us.
Please Sign In to post a comment.
More discussions in 2. Physics
- The specific torque loading for a bolt is 50 lbs.ins but an extension of 2 inches is needed to reach the bolt in addition to the 8 inches torque wrench. What will the actual reading?
- A cylinder filled with water to half a metre will exert a pressure of
- A mass of 10kg placed 2 metres away from a pivot will have a moment of
- A mass of 10kg placed 2 metres away from a pivot will have a moment of
- 25 litres of fuel exerts a pressure of 10KPa. If a further 125 litres is added, the pressure will now be
- 1000 lb/in2 is in an accumulator. If 3000 lb/in2 of hydraulic fluid is pumped in, what is the pressure on the air side?